Skoda Yeti Owner's Manual page 148

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

If the driver changes the parking mode while searching for a parking space, the
symbol button  must be pressed again.
Note
If  the symbol  (km / h) is shown in the display , the vehicle speed should be
reduced below 40 km / hr (parallel parking) or below 20 km / hr (Transverse park-
ing) .
Parking
Fig. 123 Display
First read and observe the introductory information and safety warn-
ings
on page 143.
Explanation of graphic
Parking place recognised with the information to drive on.
A
Parking place recognised with the information to engage the reverse gear.
B
Indication for selecting the forward gear.
C
Indication for selecting the reverse gear.
D
The time limit for the parking procedure with the help of the system is 6 minutes.
If the system has recognised a suitable parking space, this parking space is
shown in the display
» Fig. 123
- .
Continue driving forwards until the display appears
Stop and ensure that the vehicle does not continue to move forward until the
parking procedure starts.
Select reverse gear or move the selector lever into position R.
In the event that the parking procedure cannot be carried out in one go, the park-
ing process is completed in further stages.
The display shows the  icon (brake pedal).
The display shows the  icon (brake pedal).
You can repeat these steps several times in succession.
As soon as the parking procedure is completed, an audible signal sounds and the
following message appears in the display:
Automatic termination
The system terminates the parking procedure if one of the following cases arises.
» Fig. 123
- .
As soon as the following message is shown in the display:  Steering interv. ac-
tive. Monitor area around veh.!, let go of the steering wheel. The steering will
be taken over by the system.
Observe the direct vicinity of the vehicle and reverse carefully.
If the display shows the flashing arrow forward
first gear or move the selector lever into position D.
Depress the brake pedal and wait until the steering wheel automatically rotates
into the required position, the symbol  goes out.
Carefully drive forwards.
If the backwards arrow is flashing in the display
gear again or move the selector lever into position R .
Depress the brake pedal and wait until the steering wheel automatically rotates
into the required position, the symbol  goes out.
Carefully move backwards.
Park Assist ended. Take over steering
Speed of more than 7 km/h repeatedly exceeded during the parking procedure.
Time limit of 6 minutes exceeded for the parking procedure.
System button pressed.
Engagement of the ASR system.
TCS system switched off.
Intervention of the driver in the automatic steering procedure (stops the steer-
ing wheel).
Reverse gear disengaged or selector lever removed from the position R when
reversing into the parking space.
Selector lever moved to position P.
There is a system fault (system temporarily not available).
Automatic braking for damage limitation.
» Fig. 123
-  , then select the
» Fig. 123
- , select reverse
145
Assist systems

Advertisement

Table of Contents
loading

Table of Contents