Remove the protective grille for fog lights - sensor plug for
parking assistance
Fig. 198 Guard: Version 1/version 2
First read and observe the introductory information and safety warn-
ings
on page 238.
›
Remove the plastic cover for the guard in the arrow direction
the bow to pull the full wheel covers
›
Remove the remaining part of the grille.
›
Pull the plug on the grille gently in the direction of the arrow
1)
Use the screwdriver from the tool kit
» page 220
2)
Applies to vehicles with parking assistance system.
Fig. 199
Remove the plug
» Fig. 198
using
» page
220, Vehicle tool kit.
» Fig. 199
.
.
Replacing the bulb for the fog lights
Fig. 200 Principle sketch: Remove the number plate light / replace the bulb
First read and observe the introductory information and safety warn-
ings
on page 238.
First remove the grille for the fog lights
ing bulbs.
Remove the headlight
›
Unscrew the plastic nuts
A
›
Raise the headlights in the direction of arrow
arrow
2
.
Replacing the light bulb
›
Pull the plug on the lamp base.
›
Turn the lamp socket to the stop in the direction of arrow
it out.
›
Insert the bulb holder with the new bulb into the headlight and turn counter to
the direction of arrow
as far as the stop.
3
›
Attach the connector on the lamp base.
Refit the headlight and grille
›
Replace the fog light by inserting it in the opposite direction of the arrow
» Fig. 200
and tighten.
2
›
Attach the connector on guard carefully
›
Insert the protective grille and press it in.
›
Replace the plastic cover and press into the guard
» page 240
and
» page 241
» Fig. 200
.
1)
and remove in the direction of
1
» Fig. 200
3
» Fig. 199
on page 241
2)
» Fig. 198
on page 241
Fuses and light bulbs
before chang-
and pull
.
2)
.
241