Skoda Yeti Owner's Manual page 197

Use a care cream with light blocker and impregnation effect on a regular basis
■
and each time after cleaning. The cream nourishes the leather, allows it to
breathe and keeps it supple and also provides moisture. It also creates surface
protection.
Some clothing materials, e.g. dark denim, do not have sufficient colour fastness.
■
This can cause damage or clearly visible discolouration to seat covers, even when
used correctly. This applies particularly to light-coloured seat covers. This does
not relate to a fault in the seat cover, but rather to poor colour fastness of the
clothing textiles.
Note
When using the vehicle, minor visible changes may occur to the leather parts of
the covers (e.g. wrinkles or creases) as a result of the stress applied to the covers.
Artificial leather, cloths and Alcantara

First read and observe the introductory information and safety warn-
ings on page 192.
Artificial leather
Clean artificial leather with a damp cloth.
If this method does not completely clean the artificial leather, use a mild soap sol-
ution or cleaning products specially designed for this purpose.
Fabric
Clean upholstery cover materials and cloth trims on doors, boot cover, etc. using
specific cleaning agents, e.g., dry foam.
Use a soft sponge, brush, or commercially available microfibre cloth.
Use a cloth and a cleaning agent specifically designed for this purpose to clean
the roof trim.
Remove any lumps on the cover fabric and any fabric residue using a brush.
Remove stubborn hair using a "cleaning glove".
®
Alcantara
Dust and fine dirt particles in pores, creases and seams may chafe and damage
the surface.
If you leave your vehicle parked in the open for lengthy periods, protect the Al-
®
cantara seat covers from the direct rays of the sun to prevent fading.
194
General Maintenance

®
Minor changes in colour caused by use are normal.
CAUTION
Do not use any leather cleaners on Alcantara
■
®
For Alcantara seat covers do not use any solvents, floor wax, shoe cream, stain
■
remover, or similar agents.
Avoid leaving the vehicle in bright sunlight for long periods of time in order to
■
stop the fabric from bleaching. If the vehicle is parked outside for long periods of
time, cover the fabric to protect it from direct sunlight.
Some clothing materials, e.g. dark denim, do not have sufficient colour fastness.
■
This can cause damage or clearly visible discolouration to seat covers, even when
used correctly. This applies particularly to light-coloured seat covers. This does
not relate to a fault in the seat cover, but rather to poor colour fastness of the
clothing textiles.
Seat covers

First read and observe the introductory information and safety warn-
ings on page 192.
Electrically heated seats
Do not clean the covers by moistening, as this can damage the seat heating sys-
tem.
Use a specific cleaning agent such as dry foam or similar to clean the covers.
Seats without seat heating
Thoroughly vacuum the seat covers with a vacuum cleaner before cleaning.
Clean the seat covers with a damp cloth or cleaning products specially designed
for this purpose.
Indented points arising on the fabrics by everyday use, can be removed by brush-
ing against the direction of hair with a damp brush.
Always clean all parts of the covers, so that there are no visible edges. Then allow
the seat to dry completely.
CAUTION
Regularly remove dust from the seat covers using a vacuum cleaner.
■
Electrically heated seats must not be dried after cleaning by switching on the
■
heater.
®
seat covers.

