Adjusting, installing and removing the headrests.
Fig. 46 Head restraint: Move up / move down
First read and observe the introductory information and safety warn-
ings
on page 66.
Setting the height
›
If you want to move the headrest up, then hold this sideways with both hands
and slide as desired in the direction of arrow
›
To move the head restraint downwards, press and hold the safety button in the
direction of arrow
with one hand and press the head restraint in the direc-
2
tion of arrow
with the other hand.
3
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of the arrow
head restraint out.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
» Fig. 46
.
1
» Fig. 46
and pull the
2
Rear centre head restraints
First read and observe the introductory information and safety warn-
ings
on page 66.
Applies to vehicles using the TOP TETHER system.
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of the arrow
neously pressing the locking button into the opening in the direction of the ar-
row
using a flat screwdriver with a maximum width of 5 mm, and pull out the
2
head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Rear seats
Introduction
This chapter contains information on the following subjects:
Folding seats back into the initial position
Fig. 47
Rear seats: middle head re-
straint
» Fig. 47
while simulta-
1
68
68
68
69
70
70
67
Seats and useful equipment