Daylight Running Lights (Day Light) - Skoda Yeti Owner's Manual

Switching on the low beam

Switch on the front fog lamp » page 51

Switching on the rear fog light

Headlight beam control 
Turning the rotary switch » Fig. 25
B
headlight beam control, thereby shortening the beam of light.
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty

All seats occupied, boot empty

All seats occupied, boot loaded

Driver seat occupied, boot loaded

WARNING
Always adjust the headlight beam to satisfy the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehicles.
■
The beam range is sufficient for safe driving.
■
Note
We recommend you adjust the headlight beam when the low beam is switched
■
on.
The Bi-Xenon bulbs adapt automatically to the load and driving state of the ve-
■
hicle when the ignition is switched on and when driving. Vehicles that are equip-
ped with Bi-Xenon headlights do not have a manual headlight range adjustment
control.
The light switch is in position  or  and the ignition is turned off, the low
■
beam is switched off automatically and the status light is lit. The side light goes
out after the ignition key is removed.

Daylight running lights (DAY LIGHT)


First read and observe the introductory information and safety warn-
ings on page 47.
The daytime running lights (the only function) provides the lighting of the front
vehicle range.
48
Using the system
» page 51
from position  to  gradually activates the
The daytime running lights are switched on automatically if the following condi-
tions are met:
The light switch is in position  or 
A

The ignition is switched on.

The parking aid is activated.

Deactivating the function
›
Switch off the ignition.
›
Pull the turning signal and main beam lever towards the steering wheel, push
down and hold in this position.
›
Switch on the ignition.
›
Hold the lever in this position for at least 3 seconds after the ignition is switch-
ed on.
Activating the function
›
Switch off the ignition.
›
Pull the turning signal and main beam lever towards the steering wheel, push it
up and hold it in this position.
›
Switch on the ignition.
›
Hold the lever in this position for at least 3 seconds after the ignition is switch-
ed on.
On vehicles with MAXI DOT display, the function can be enabled or disabled in the
menu item Dayl. dri. light » page
Note
When the daytime running light is switched on, the side lights (neither at the
front or rear) and the number plate lights are not lit.

» Fig. 25 on page 47.
29, Settings .
