Table of Contents
Advertisement
Check proper fitting
First read and observe the introductory information and safety warn-
ings
on page 152.
Check that the tow bar is fitted properly before each use.
Check the following points.
The tow bar does not come out of the mounting recess even after heavy
"shaking".
The green marking
» Fig. 131
A
on the tow bar.
The handwheel lies flush with the tow bar - there is no gap.
The cover
is attached to the locked handwheel lock.
B
WARNING
Do not use the towing device unless the tow bar has been properly locked!
Fig. 131
Check that the tow bar is attach-
ed properly
on the handwheel is located in the green box
Removing the ball rod
Fig. 132 Removing the lock cover/releasing the lock
Fig. 133 Removing the two bar/placing the cover on the rear bumper
First read and observe the introductory information and safety warn-
ings
on page 152.
›
Remover the cover
from the handwheel lock in the direction of the arrow
A
» Fig. 132
.
1
›
Insert the key into the handwheel lock.
›
Release the handwheel lock by turning the key
of the arrow
to the stop.
2
›
Grip the tow bar from below and with the other hand pull the handwheel
the direction of the arrow
3
›
Turn the handwheel in the direction of the arrow
this position.
›
Remove the tow bar from the mounting recess downwards and in the direction
of the arrow
.
5
to the right in the direction
B
» Fig.
133.
to the stop, and hold in
4
Towing a trailer
C
in
155
Advertisement
Chapters
Table of Contents
