Turn Signal And Main Beam; Automatic Driving Lamp Control - Skoda Yeti Owner's Manual

Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

Turn signal and main beam

First read and observe the introductory information and safety warn-
ings
on page 47.
Operating lever positions
» Fig.
26.
Switch on right  turn signal
A
Switch on left  turn signal
B
Switch on main beam  (spring-tensioned position)
C
Switch on main beam or headlamp flasher (spring-loaded position) 
D
The parking light can also be controlled with the control lever
Main beam
The main beam can only be switched on when the low beam lights are on.
When the high beam or headlight flasher is on, the warning light
the instrument cluster.
Flashing
When the left or right turn signal is on, the warning light
instrument cluster.
The flashing light is turned on even before the upper and lower pressure point.
This is advantageous in certain driving manoeuvres. For example, when changing
lanes hold the control lever of each pressure point.
The turn signal light switches itself off automatically when driving around a curve
or after making a turn.
The indicator light flashes at twice its normal rate if a bulb for the turn signal light
fails.
Fig. 26
Operating lever: Turn signal and
main beam operation
» page
53.
illuminates in
or
flashes in the
"Convenience turn signal"
If you only wish to flash three times, briefly push the lever to the upper or lower
pressure point and release again.
The "Lane ch. flash" can be activated or deactivated via the Maxi DOT display in
the Lane ch.
flash» page
29, Settings menu item.
WARNING
Only turn on the main beam or the headlight flasher if other road users will
not be dazzled.
Note
The headlight flasher system can also be operated if the ignition is switched off.

Automatic driving lamp control

First read and observe the introductory information and safety warn-
ings
on page 47.
If the light switch is in position 
number plate lights are switched on or off automatically.
The light is regulated based on data gathered by the sensor fitted in the holder of
the rear-view mirror below the windscreen.
If the light switch is in position , the symbol  lights up next to the light
switch. If the light is switched on automatically, the symbol  next to the light
switch also lights up.
Fig. 27
Light switch: AUTO position
» Fig.
27, the parking lights, low beam and
Lights and visibility
49

Advertisement

Table of Contents
loading

Table of Contents