Variable Loading Floor In The Luggage Compartment (Estate); Class N1 Vehicles - Skoda Yeti Owner's Manual

Replace batteries » page 232.
Luggage compartment light
If the light is in the holder, it is automatically switched on when the boot lid is
opened.
If the lamp is in the holder, it is automatically switched off when the boot lid is
closed.
CAUTION
The removable lamp is not watertight and must therefore be protected against
■
moisture.
If the lamp is not switched off and it is correctly inserted in the holder, the bulbs
■
in the front part » Fig. 86 of the lamp are automatically switched off.
A
If the lamp is not correctly inserted into the holder, it does not light up when
■
the boot lid is opened and the rechargeable batteries are not charged.

Class N1 vehicles


First read and observe the introductory information and safety warn-
ings on page 81.
On class N1 vehicles, which are not fitted with a protective grille, a lashing set
which complies with the standard EN 12195 (1 - 4) must be used for fastening the
load.
Proper functioning of the electrical installation is essential for safe vehicle opera-
tion. It is important to ensure that the electrical installation is not damaged dur-
ing the adjustment process or when the storage area is being loaded and unloa-
ded.
Variable loading floor in the luggage compartment
(Estate)

Introduction
This chapter contains information on the following subjects:
Removing and inserting the variable loading floor
Securing the loading floor in the raised position
88
Using the system
Removing and refitting carrier rails
Using the variable loading floor with a spare wheel
The variable loading floor makes it easier to handle bulky goods and creates an
even boot floor when the rear seat backrests are folded forward.
CAUTION
The maximum permissible load of the variable loading floor is 75 kg.
Note
The room under the variable loading floor can be used to stow objects.
Removing and inserting the variable loading floor

Fig. 87 Fold up variable loading floor/remove

First read and observe the introductory information and safety warn-

ings on page 88.
›
Fold the variable loading floor together using the handle
rection of » Fig. 87 .
1
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
Insertion takes place in reverse order.
88
89
89
90

and fold in the di-
A
.
2
.
3
.
4
