Park Assist; Switching On/Off - Skoda Yeti Owner's Manual

The distance behind the vehicle is approximately 200 cm.
C
Detection range of the camera.
D
Area outside the detection range of the camera.
E
CAUTION
The orientation lines are immobile, and therefore the spacing of the bars behind
■
the vehicle will vary, depending on the vehicle load state and the road inclination.
The orientation of strokes not for use at a distance estimation approach to the
■
above objects, such as a towing hitch and the rear of a truck, etc.

Switching on/off


First read and observe the introductory information and safety warn-
ings on page 141.
Switching on
The system is activated automatically by engaging the reverse gear.
Switching off
The system is turned off when any of the following is present.
›
The reverse gear is disengaged.
›
The symbol key  is pressed.
›
The speed of 15 km/h is exceeded.
›
The ignition is switched off.
For cars without PDC (OPS), the system is turned off about 10 seconds after re-
moving the reverse gear.
Note
In vehicles with front and rear parking aid sensors, parking assistance (OPS) is au-
tomatically displayed after disengaging the reverse gear.

Park assist


Introduction
This chapter contains information on the following subjects:
Finding a parking space
Parking
Manoeuvring out of a parallel parking space

Automatic brake assist
Information messages
The parking aid is part of the park assist system, therefore the information and
safety guidelines » page 140, Parking aid must be read and observed.
Park Assist (in the following referred to as the system) helps drivers park in suita-
ble parallel and perpendicular parking places and also to manoeuvre out of paral-
lel parking spaces.
The system only operates if the ignition is switched on.
The displays, messages and system instructions are displayed in the MAXI DOT
display (in the display only below).
During the parking procedure the system only takes over the steering move-
ments, the pedals continue to be operated by the driver.
When the system is activated, the warning light lights up 
page 144 - .
The traction control system (TCS) must always be switched on when parking.
Basis of the system function
›
The measurement and evaluation of the size of parking spaces when driving.
›
The determination of the correct position of the vehicle for parking.
›
The calculation of the line on which the vehicle drives backwards into the park-

ing space or forwards from the parking space.
›
the automatic turning of the front wheels when parking in, or manoeuvring out
of the parking space.
144
145
146
146
146
» Fig. 122 on

143
Assist systems