Wheel Lock - Otto Bock Dino 3 Service Manual

5.8 Wheel Lock

Setting/Replacing the wheel lock
After loosening the two screws the distance between
the wheel lock and rear wheels can be changed.
Remove the two screws in order to remove the wheel
lock.
Tighten the screw connection on the wheel lock with
a torque of 15 Nm (11 lbf.ft./132.8 lbf.in.).
READ: For setting the wheel lock,
please observe the information given
in the instructions for use manual and
observe the correct distance to the rear
wheel.
Retrofitting the (plug-on) wheel lock lever exten-
sion
Cut open the wheel lock lever handle cover and peel
it off the wheel lock lever.
30
Caution! The user can get injured by the
brake block. When making settings on
the distance between rear wheel and
side panel or when changing the wheel
camber, ensure that the brake block is
in the correct position. With a protruding
brake block there is the risk for the user
to get their hands injured. The brake block
should reach over the wheel up to at least
3/4 of the tread width, but not beyond the
wheel. In the spare parts catalog you can
choose among brake block of different
length.
Replace the cap screw (A) with the longer cap
screw provided.
Plug the wheel lock lever extension onto the wheel
lock lever and screw the cord to the thread end that
protrudes from the clamp attachment.
A