Frame - Otto Bock Dino 3 Service Manual

5 DINO 3

5.1 Frame

Replacing the frame
In order to replace the frame, first remove all compo-
nent groups and accessories which are connected
to the frame.
- Anti-tipper (refer to section 5.1)
- Tip-assist (refer to section 5.1)
- Seat with back (refer to section 5.3)
- Side panels (refer to section 5.5)
- Casters (refer to section 5.6)
- Rear wheels (refer to section 5.7)
- Wheel locks (refer to section 5.8)
Replacing/Retrofitting/Setting an anti-tipper
READ: For mounting and setting
the anti-tipper please observe the
information given in the instructions
for use manual and in the spare parts
catalog.
Replacing/Retrofitting the receiver tube for acces-
sories
For the attachment of an anti-tipper or tip-assist to
models equipped with 12" rear wheels, a receiver
tube for accessories is required. Receiver tubes for
accessories must be mounted before mounting the
wheel attachments.
Screw the receiver tube for accessories to the
frame's vertical end tube as shown in the photo.
Use new, self-locking nuts.
Replacing/Retrofitting a tip-assist
The tip-assist may be attached on the left or the right
side.
With the spring button of the tripod spring pressed
down insert the tip-assist from underneath into the
receiver tube for accessories or into the frame's
vertical end tube and let the tripod spring engage in
the lowest bore hole.
7