Back / Push Handle - Otto Bock Dino 3 Service Manual

5.4 Back / Push Handle

A
Replacing the back
Loosen and remove the screw connection between
the back angle adjustment mechanism and the back
frame (A) and fold the back down onto the seat.
Loosen and remove the cable holders.
Note: These screws hold the wire loops
that secure the push handles/pushbar.
Loosen and remove the screw connection between
the back and the side plates on the seat.
Open the adjustment levers of the height adjustment
on the left and right side of the back frame and pull
the push handles/pushbar out of the back frame.
For reassembly, please proceed in reverse order.
Use new, self-locking nuts.
21