Accessories - Otto Bock Dino 3 Service Manual

5.9 Accessories

C
A
Replacing/Retrofitting/Adjusting the knee angle
Loosen the set screws (A) on the seating shell
interface (C) and pull out the knee angle (B). Now
change the depth position.
Loosen the set screws (D) on the footrest. Slide the
footrest off the tubes or up and down to adjust the
position.
For reassembly, please proceed in reverse order.
Replacing the heel plate/footplate support
The heel plate and footplate support are secured
with four rivets (F) each.
Drill the rivets from the head side using a drill bit
(Ø 5 mm) until the head comes loose. Then drive
the rivets through the receivers using a pin punch
(Ø 3 mm). Fasten the new plates with rivets.
32
B
D
F
F
E
Setting the footplate angle/Replacing the foot-
plate
Loosen the screw connection between footrest slide
and footplate (E). Now adjust the footplate angle in
the guiding slot or remove the screw connection to
replace the fooplate or slide.
Trapezoid adapter for seating shells
READ: Please observe the information
given in the instructions for use manual.