Footrests - Otto Bock Dino 3 Service Manual

5.2 Footrests

Replacing/Retrofitting the footrest assembly
All footrest assemblies are attached to the seat tube
with the seat depth adjuster/holder.
READ: For operation and setting
please refer to the information given in
the instructions for use manual.
A
Replacing/Retrofitting/Shifting the footrest re-
ceiver with angle adjustment
First remove the stopper plugs from the seat tube
ends. Insert the footrest receiver into the seat bar
and fasten the footrest receiver (A) with the four
screws to the seat bar. The row of holes in the seat
bar allows depth adjustment of the footrest receiver.
For disassembly, please proceed in reverse order.
Use new screws with thread lock.
8
B
Replacing/Setting the seat depth adjuster/holder
Loosen and remove the screw connections on the
seat tube (A) and either change the seat depth set-
ting or completely pull the tubes of the seat depth
adjuster out of the seat tubes.
Next, loosen and remove the screw connection
between the seat depth adjuster and footrest hold-
er (B) and replace the seat depth adjuster.
Replacing the footrest holder
Remove the calf band.
Undo the lock as shown in the photo, swing the
footrest holder outwards and pull it upwards off the
footrest receiver.
For reassembly, please proceed in reverse order.
A