Caster - Otto Bock Dino 3 Service Manual

Retrofitting the clothing protector 471E42=PK010
Remove the rear wheels (22"/24").
Mount the clothing protector holders as shown in the
photo on the left and right side of the frame.

5.6 Caster

5 mm
Caution!
Bald tires can lead to accidents. This
results in a risk of injuries for the per-
son transported in the product! For
this reason, wheels with solid material
tires such as PU or EVA foam must be
replaced if the material shows signs of
cracking or damage, or when the tread
becomes worn down to such an extent
that there is only 5 mm of radius left on the
outer edges of the tire. For this reason,
the casing of pneumatic tires must be
replaced if it is bald or shows signs of
cracking or other damage.
Setting the plastic part and the armrests
After loosening and removing the screw connections
in the middle of the clamping plate, the row of holes
can be used for changing the armrest height setting.
After loosening and removing the four outer screws
in the clamping plate, the rows of holes can be used
for changing the depth and height setting of the
plastic part.
After loosening the four outer screws the bolts can
be moved in the clamping plate and thus the height
of the clothing protector adjusted.
5 mm
Replacing/Changing the position of the front
wheels
Loosen and remove the screw connection and take
the front wheel out of the caster fork.
For reassembly, please proceed in reverse order.
Use new, self-locking nuts. Tighten the screws with a
torque of 10 Nm (7.4 lbf.ft./88.5 lbf.in.).
Note: The front wheel can be set to one
of four heights.
25