Self Diagnostics Function (Error); Self Diagnostic Items - Toho Electronics TRM-10C Instruction Manual

10.2

Self Diagnostics Function (ERROR)

This instrument always makes a self diagnostics on the items listed in Table 10.1 below. When an
error is found in the self diagnostics results, a relevant error number is displayed.
10.2.1

Self Diagnostic Items

Table 10.1 Status output list
Error
Type
message
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
• m Note1• n The lifetime of the cell assumes about 10 years but sometimes depends on the use environment.
Parts
Zero point Zero point position of servomotor
sensor cannot be detected.
AD conversion end error, Initializing
ADC
error
IC for clock The clock battery runs down• m Note1• n
WDT Watchdog timer error
EEP
Non-volatile memory Writing error
WRITEWRITE
Non-volatile memory Reading error
EEP READ1
(Setup data)
Non-volatile memory Reading error
EEP READ2
(Engineering data)
Non-volatile memory Reading error
EEP READ3
(ADC Calibration data)
Area error Input value is over the setting range.
Time error Clock time setting error
Setting the channel (CH1) which
Setting range
cannot set up the
error
sum/difference/average operation.
Area error Span L • †
Area error Scale L • †
Zone L • †
Area error
Zone R• | Zone L is less than 5mm.
The reference channel range of the
Setting channel
sum/difference/average operation is
error
except Volt, TC, RTD and SCALE.
All channels
Setting the Skip all channels.
skip error
Calibration It is not calibrating to the specified
value input error input.
98• \
Diagnostic
Span R
Scale R
Zone R or
Remedy
Contact our
dealer where you
purchased the
instrument or our
sales
representative.
Set properly
Calibrate a
correct input.
HXPRM10mnCT001E