Outputting The Process Variable Data; Specifying The Process Variable Data Output; Updating The Data; Specifying The Process Variable Data Output Order (At Binary Mode Output) - Toho Electronics TRM-10C Instruction Manual

8.3

Outputting the Process Variable Data

8.3.1
‚ O • i ‚ b ‚ q • j • i ‚ k ‚ e • j
• @ ‚ s ‚ r
Once this command is received, the recorder transfers the process variable data to the transmit buffer,
when the (ESC) T command is received.
8.3.2
• @ • i ESC• j ‚ s • i ‚ b ‚ q • j • i ‚ k ‚ e • j
Once this command is received, the recorder transfers the update process variable data to the
transmit buffer.
8.3.3
• @ ‚ a ‚ n ‚ O • i ‚ b ‚ q • j • i ‚ k ‚ e • j
• @ ‚ a ‚ n ‚ P • i ‚ b ‚ q • j • i ‚ k ‚ e • j
The recorder outputs starting from the lower byte, unless otherwise specified.
8.3.4
‚ O • C ‚ r • Q ‚ b ‚ g • C ‚ d • Q ‚ b ‚ g • @
• @ ‚ e ‚ l
• @ ‚ e ‚ l ‚ P • C ‚ r • Q ‚ b ‚ g • C ‚ d • Q ‚ b ‚ g • @
• @ ‚ r • Q ‚ b ‚ g :Output start channel ‚ O ‚ P to ‚ O ‚ U
:Output end channel ‚ O ‚ P to ‚ O ‚ U
• @ • @ • @ • @ • @ • @ • @ • @ ‚ d • Q ‚ b ‚ g
• ¦ When the number of channels is one, specify (S_CH) = (E_CH).

Specifying the Process Variable Data Output

Updating the Data

Specifying the Process Variable Data Output Order (At BINARY Mode Output)

• @ • @ Outputs starting from the upper byte.
• @ • @ Outputs starting from the lower byte.

Outputting the Data

• @ • @ • @ Specifies the ASCII mode output.
• @ • @ • @ Specifies the BINARY mode output.
84• \
HXPRM10mnCT001E