Mounting To The Panel; Procedure For Mounting To The Panel - Toho Electronics TRM-10C Instruction Manual

3.2 Mounting to the Panel

Do not install the instrument in a place exposed to a combustible, explosive, or corrosive gas (SO
etc.).
Install the instrument in the following places
• @ • E A place free from where humidity often changes.
• @ • E A place of normal temperature (25• Ž
• @ • E A place exposed to as little mechanical vibrations as possible.
• @ • E A place with as little dusts as possible.
• @ • E A place affected by the electromagnetic field as little as possible.
• @ • E A place not directly exposed to high radiant heat.
• @ • E A place where the altitude is up to 2000m.
• @ • E Humidity has an effect on the chart paper and ink. Use the instrument in a humidity range of 20 to
• @ • @ 80%RH (60%RH is optimum).
• @ • E This instrument needs the inside installation.
Mounting to the Panel
• E A steel plate not thinner than 1.2mm is recommended as a mounting panel.
• E The maximum thickness of the mounting panel is 7mm.
Inclination
• E Install the instrument horizontally.
• E The instrument should be installed so that its inclination should be 0• K at the front and within 30• K at the
rear.

3.2.1 Procedure for Mounting to the Panel

1) Assemble the mounting bracket refer to Fig.3.2.
2) Fit in this instrument through the front of the panel.
3) Fit the claws of the mounting bracket into the square holes in the top and bottom surfaces of the
4) Tighten the screw of the mounting bracket with a screwdriver to attach it to the panel. When the
Assemble in such a manner
that the screw nose will be
almost aligned with the plate
surface.
• @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @ • @
[Note]
If it is tightened with an excessive force, the case may be distorted and the mounting bracket may be
deformed. An adequate tightening torque is about 0.2 to 0.3 N¥ m (2• ` 3 kgf• E cm).
WARNING
CAUTION
case.
mounting unit does not move back and forth any more, tighten a screw by 180 ß .
or so).
Mounting Claw
Fig. 3.2• @ Mounting bracket
13• \
Body
Mounting Claw
HXPRM10mnCT001E
, H S,
2 2