(Square Root) - Toho Electronics TRM-10C Instruction Manual

(4)• @ (Square Root)
Caluclates the square root of Volt input, and scaling that value.
Setting the unit is possible. (See 7.1.3 on page 56)
Example) When setting the voltage of 0 to 40 mV and scale of 000.00 to 100.00 for Channel 1.
Display




 
(Zero input value)
 
(Span input value)
 
(Zero-side scale value)
 
(Decimal point)
 
(Span-side scale value)

[Note]
An entry of an incorrect numeral indicates an error,
 
Press the • g ENT• h key and re-enter a correct numeral.
Operation keys
ESC
3sec
MENU
ENT
PRINT
ENT
PRINT
ENT
PRINT
ENT
PRINT
PRINT
FEED
ENT
PRINT
FEED
ENT
PRINT
FEED
PRINT
FEED
ENT
PRINT
FEED
ENT
ENT
 
• @ • @ or • @ • @ • @ • @ • @
48• \
Description
Hold down the • g MENU• h key for 3 seconds or more
to enter the setup mode. Use the • ¢
"". Press the • g ENT• h key.
Use the • ¢ key to select the channel you want to set.
Press the • g ENT• h key.
Use the • ¢ key to select "". Press the
• g ENT• h key.
Use the • ¢ key to select a range(50 mV). Press the
• g ENT• h key.
key to select a numeral. Use the  key
Use the • ¢
to shift a digit. Press the • g ENT• h key.
key to select a numeral. Use the  key
Use the • ¢
to shift a digit. Press the • g ENT• h key.
key to select a numeral. Use the  key
Use the • ¢
to shift a digit.
Press the  key again in the lowest digit(right end)
to blink a decimal point. Use the • ¢
decimal point position. Press the • g ENT• h key.
key to select a numeral. Use the  key
Use the • ¢
to shift a digit. Press the • g ENT• h key.
Press the • g ENT• h key. Setting is completed. To
return to the user mode, hold down the • g MENU• h
key for 3 seconds or more.
 
.
key to display
key to select a
, or
HXPRM10mnCT001E