Point Calibration - Toho Electronics TRM-10C Instruction Manual

7.2.11 Point Calibration

Calibrate a dot printing position.
 Calibration of the zero point position
• F
 Calibration of the span point position
• F
[Note]
 and "
Point calibration "
Example) When calibrating the zero point.
Display
• @  



Example) When calibrating the span point.
Display
• @  



 are setup item before shipment. Do not change the setup value.
• h • h
Operation keys
ENT
ENT
PRINT
ENT
PRINT
PRINT
FEED
ENT
Operation keys
ENT
ENT
PRINT
ENT
PRINT
PRINT
FEED
ENT
78• \
Description
Enter the engineering mode (See the key operation
in page 67). Use the • ¢
" • @  ", and press the • g ENT• h key.
Use the • ¢ key to select "", and press the
• g ENT• h key.
The instrument starts to feed and print the chart
paper. With the • ¢ (left move) and  (right move),
adjust the 0 mm position of the chart paper and the
recording position. Press the • g ENT• h key. Display
displays the set counter value.
Setting is completed. Returned to the Zero Point
Calibration screen.
Description
Enter the engineering mode (See the key operation
in page 67). Use the • ¢
" • @  ", and press the• g ENT• h key.
Use the • ¢ key to select "", and press the
• g ENT• h key.
The instrument starts to feed and print the chart
(left move) and  (right move),
paper. With the • ¢
adjust the 100 mm position of the chart paper and
the recording position. Press the • g ENT• h key.
Display displays the set counter value.
Setting is completed. Returned to the Span Point
Calibration screen.
key to display
key to display
HXPRM10mnCT001E