Di Functions; Temperature Unit - Toho Electronics TRM-10C Instruction Manual

7.2.9 DI Functions

Allocate the functions to three DIs. There are the following 12 DI functions.
No function
Manual print (Sync.)
Manual Print (Async.)
RUN/STOP trigger function
Date/Time Print (Sync.)
Date/Time Print (Async.)
Chart speed selection
Comment print 1-3 (Sync.)
Comment print 1-3 (Async.)
Example) When setting comment prints 3 for DI3.
Display




• m Note• n
The setting is OFF without the DI option. Do not set any setting except for OFF.

7.2.10 Temperature Unit

It changes the setting of a temperature unit.
Example) When setting a temperature unit to being Fahrenheit.
Display



• m Note• n
When changes temperature unit, all set up data (configuration) becomes initial.
: 
:  (Positive edge: running start)
: (Positive edge: running start)
:  (ON:RUN, OFF:STOP)
:  (Positive edge: running start)
:  (Positive edge: running start)
:  (ON:Spd-1, OFF:Spd-2)
   (Positive edge: running start)
: ¤ ¤
   (Positive edge: running start)
: ¤ ¤
Operation keys
Enter the engineering mode (See the key operation
ENT
in page 67). Use the • ¢
ENT
PRINT
"", and press the • g ENT• h key.
Use the • ¢
ENT
PRINT
• g ENT• h key.
Use the • ¢
ENT
PRINT
the • g ENT• h key.
Setting is completed. Returned to the DI3 Function
Setting screen.
Operation keys
Enter the engineering mode (See the key operation
ENT
in page 67). Use the • ¢
ENT
PRINT
"", and press the • g ENT• h key.
Use the • ¢
ENT
PRINT
key.
Setting is completed. Returned to the Temperature
Unit Setting screen.
77• \
Description
key to display
key to select "", and press the
key to display "", and press
Description
key to indicate
key to select "", and press the • g ENT• h
HXPRM10mnCT001E