PolyVision CopyCam Installation And Operation Manual page 9

3
1
4
2
11
12
13
CopyCam Installation
5
8
10
CopyCam E
7
Control
Pad
Mounting
Template 3 3
9
4 4
Figure A
800.620.POLY
678.542.3100
+32.089.32.31.30
370-0140-01
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
Place four of these on the writing area. Align each corner of the writing
area with this corner on each sheet. Use four pieces of type to ensure
that each sheet lies flat.
16
17
20
21
18
19
6
CopyCam
Camera Arm Required minimum
Mounting clearance 14" (35cm)
Template from board to ceiling
Figure B
6 6
Place template in the
center of the top edge
of the whiteboard
or chalkboard
(see figure B)
7 7 8 8
Mark cable hole if
Mark these four
holes for wall anchors installing cables in-wall
1 1
5 5
Fold on
Mark these four 800.620.POLY
this line
holes for wall anchors 678.542.3100
+32.089.32.31.30 Fold on this line
Center of whiteboard or chalkboard
370-0115-01
2 2
Place template against
Mark cable hole
if installing the lower left corner
cable in-wall of the whiteboard
or chalkboard
(see figure A)
Center arrow at top of writing area,
under CopyCam arm.
Center arrow at top of writing area,
14 under CopyCam arm.
Corner Calibration Sheet
Corner Calibration Sheet
Corner Calibration Sheet
Top Center Calibration Sheet
Corner Calibration Sheet Top Center Calibration Sheet
15
22
23
5