Table of Contents
Advertisement
Preparing to Install the Control Pad
WARNING
You must fasten the brackets to the wall so they are secure. CopyCam
mounts to any kind of wall construction. Instructions and wall fasteners are
provided to help you install CopyCam when walls have metal or wood
studs. Be sure to locate studs and use them to drive mounting screws
whenever possible.
Locate and have ready to use:
control pad positioning template
•
control pad
•
control pad mounting plate
•
two #8 x 1.5" (38mm) drywall screws (provided)
•
four toggle bolts (provided)
•
four toggle bolt screws (provided)
•
power drill with 1/2" (12mm) bit
•
power screwdriver with phillips bit, or phillips screwdriver
•
pencil
•
tape measure (optional)
•
Installing the Control Pad Mounting Plate
These instructions guide you through installing CopyCam on a sheetrock
wall. If your wall material is some other substance, such as concrete or
brick, use these instructions as a guideline but install appropriate anchors
to secure the unit to the wall.
To position the control pad mounting plate:
1
Identify which side of the control pad mounting template is appropriate
for your installation: CopyCam Pro or CopyCam E.
2
Punch holes in the control pad positioning template at the locations of
the four screws.
CopyCam Installation
9
Advertisement
Table of Contents
Need help?
Do you have a question about the CopyCam and is the answer not in the manual?
Questions and answers