Led And Voice Status Messages; Led Status Indicators - PolyVision CopyCam Installation And Operation Manual

ISSUE
The password for the Setup
tab has been lost or
forgotten.
LED V
AND OICE
CopyCam gives you both LED and voice feedback to indicate the status of
your capture. The LED is located on the control pad.

LED Status Indicators

The table below explains the LED status indicators.
LED INDICATOR
No light
Solid green
Blinking yellow
Solid yellow
Blinking red
62
• Reset the system to factory settings, which
results in the loss of all settings and stored
images. To reset the system:
1 Remove the power adapter from the wall for
5 seconds.
2 Plug the power adapter back into the wall.
3 Wait about one minute for the control pad
LED to blink green once, then immediately:
CopyCam Pro: simultaneously press all three
control pad buttons and hold until the control
pad LED turns red.
CopyCam E: press the
until the control pad LED turns red.
4 Release the button(s). The voice message
says "Hello" when CopyCam is finished
resetting.
S M
TATUS ESSAGES
No power.
Unit is idle and ready to copy.
Board capture in progress, unit is powering on, or
firmware upgrade in progress. Stand away from
the board during captures.
Copy is being processed for the floppy disk drive,
printer, or web server. You may continue writing on
the board. The capture is complete.
System error such as missing or full diskette,
printer out of paper or not powered on, or
calibration required. (The voice message provides
additional information.)
RESOLUTION
button and hold
SYSTEM STATUS
Troubleshooting