PolyVision CopyCam Installation And Operation Manual page 38

To configure CopyCam:
1 On a computer connected to the same LAN and subnet as the
CopyCam installation, insert the CopyCam configuration CD-ROM.
note: NOTE:
When you use the software on this CD-ROM, you can find only CopyCam
systems that are on the same network segment (subnet) as your computer.
After the IP address of your new CopyCam has been located (in step 4,
below), you can browse to that address from any computer in your local
area network (LAN) regardless of which segment it is on.
2 Double-click the "setup" file.
3 For DHCP-based networks: Click "Start" to locate all CopyCam
systems on your LAN and display their IP addresses.
For fixed-address networks: Click "Start" then click "Start" again to
locate all CopyCam systems on your LAN and display their IP
addresses.
NOTE: note:
If you are not sure how your network is configured, ask your IT department
or System Administrator.
note: NOTE:
If no CopyCams appear, close the window and once again double-click the
"setup" file. (CopyCam performs IP address squatting only after the first
time you click "Start.")
34 Web Configuration and Testing