PolyVision CopyCam Installation And Operation Manual page 48

3 If this is the first change you have submitted during this Internet
browser session, the Password dialog appears, as shown below.
4 Enter your password. The user name is blank and the factory default
password is "admin."
5 Click "OK."
6 CopyCam automatically connects to the IP address, downloads the
update, and then upgrades the firmware. Depending on the speed of
the Internet connection, this may take up to two minutes.
The control pad LED provides feedback regarding the status of the
upgrade. During the upgrade, the LED goes through a pattern of
blinking yellow then green, then blinking yellow and green again. At the
completion of a successful upgrade, the control pad voice message
says "hello" and the LED stays green.
If the upgrade fails, the control pad LED flashes red. Press any control
pad button to resume use with the original firmware version.
WARNING
Do not disconnect the power while the control pad LED is flashing.
Permanent damage may result.
7 After the upgrade, click the browser's "Back" button to return to the
CopyCam web page. (Do NOT click the browser's "Refresh" button,
as this will initiate the upgrade again.)
note: NOTE:
You can also update CopyCam Pro firmware from a floppy diskette
provided by PolyVision Corporation. Contact Technical Support if you need
such a diskette.
44 Web Configuration and Testing