PolyVision CopyCam Installation And Operation Manual page 58

CopyCam Pro uses only formatted MS-DOS high-density 3.5" floppy
diskettes. Formatted floppy diskettes are available from most office supply
stores.
note: NOTE:
CopyCam Pro will not erase files on a diskette, so be sure that the diskette
you use has sufficient space for your copies.
To copy to a floppy diskette:
1 Insert a formatted diskette in the control pad, as shown below.
2 When you are ready to capture, press
to the floppy diskette.
3 Continue your presentation after you hear the voice message say
"captured" and the LED changes from blinking yellow to solid yellow.
The disk drive begins to write after about 30 seconds. Writing to disk
may take up to a minute.
note: NOTE:
If the LED blinks red, one of the following may have occurred:
No diskette is inserted in the control pad.
•
A bad or unformatted diskette is inserted in the control pad.
•
The diskette is full.
•
The voice message provides additional information.
54
to save a copy of the board
CopyCam Operation