Technical Specifications; Agency Regulatory Notices; Complies To "Ce" Mark Requirements; Emc Directive 89/336/Eec - Bryce 9K-L User Manual

Notice: Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Federal Communications Commission Compliance
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1). This device may not cause harmful interference, and
2). This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with FCC Rules Part 15 subpart B Class B
for a digital device. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
This device complies with the requirements of the following standards:
Complies to "CE" Mark requirements of:
• EMC Directive 89/336/EEC and as AMENDED
• Low Voltage Directives 73/23/EEC and as Ammended

EN 55022, CLASS B,

"Conducted and Radiated Emissions"
EN 50081-1: 1992
"Radiated Emissions"
EN 50082-1:1992,
"General Immunity Standard: Residential, Commercial, and Light Industry"

IEC 801- 2: 1984

"Electrostatic Discharge"

IEC 801- 4: 1988

"Electrical Fast Transients, I/O and Power"
Revision A

AGENCY REGULATORY NOTICES

9K-LC USERS MANUAL
P/N 90-00870-001
Appendix G Technical Specifications
Section G - 1