Printer Tips; Output Stack Height - Bryce 9K-L User Manual

Adjusting
the Left and
Right Exit
Roller
Slider
Output
Stack
Height
Revision A
Push the Exit Roller Slider left or right to move the slider to a
new position on the shaft. Place the Sliders to 1/4 of an inch
(6.35 mm) from the left and right edges of the media. It is
important to check that the Sliders do not contact any printed
information on the media. If the rollers do roll over any
printed areas they will act as a brush with paint and smear the
print. Move the rollers in more or out more toward the nearest
clear zone (non printing area of the media).
The Paper Catch Assembly will stack up to five (5) inches
(12.7 cm) of media before it is necessary to remove the stack
from the paper catch assembly. If the paper catch is not
emptied regularly then there is the potential for the stack to be
out of sequence, particularly when the printer is printing
toward the top of the media.
9K-L USERS MANUAL
P/N 90-00860-001

Printer Tips

Section 5 - 1