Bryce 9K-L User Manual page 2

WARNING: HIGH VOLTAGES ARE PRESENT BEHIND THE COVERS AND IN THE PAN ASSEMBLY.
Never remove the pan access cover assembly or rear cover assembly since there are no user serviceable parts
inside. The electrical and/or sensitive parts may only be serviced by an authorized Service Representative.
Important Safeguards
To reduce the risk of fire and/or electric shock, do not attempt to disassemble this machine.
The machine is not intended for use in hazardous locations. Do not use in environments known to
contain flammable or explosive gases.
To prevent overheating, do not cover vent openings or use the machine over a radiator or heat register.
To reduce the risk of injury, refer all non-operator service functions to qualified service personnel.
Access only those operator designated areas of machine for jam clearing. All other areas of machine
requiring disassembly or removal of covers should only be accessed by qualified service personnel.
This machine cabinet serves to enclose hazardous parts. If the machine has been dropped or otherwise
had the cabinet stressed in any way, report it to your local service representative.
In the performance of operator service procedures, be certain the machine is unplugged from the wall.
Do not attempt to use this product in an unauthorized manner. To do so may expose you to mechanical
and / or electrical hazards.
Do not expose power cord to sharp points or edges.
To protect against shock, the power cord must only be plugged into a grounded receptacle. The ground
pin on the plug must never be removed.
The power cord should be routed so it cannot be walked upon.
Do not operate this machine with a damaged power cord or plug.
Unplug or otherwise disable this machine before cleaning.
Know how to turn off power in the work area, and to summon help in the event of an emergency.
Do not remove safety covers for cleaning, adjustments or repairs. Call your service representative.
Keep office supplies such as paper clips, staples, rubber bands, etc., away from machine.
Keep loose clothing ties, jewelry, and long hair away from moving parts of this machine.
Ink formulations for use in this machine are critical. Use only those specified.
Notice: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Treat every circuit as if it were live. Check first with a neon tester or a voltmeter.
Federal Communications Commission Compliance
"This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1). This device may not cause harmful interference, and
2). This device must accept any interference received, including interference that may cause
undesired operation.
WARNING
:Read all instructions before attempting to operate this equipment.