Bryce 9K-L User Manual page 65

SYMPTOM
Print Quality Problems
(No print)
Non Uniform Print Quality
Ink Streaking on Media
Ink Print Quality is not
sharp
Print is Skewed
(Skew Specification +/- 2
1/2 degrees of bottom
edge.)
Print Quality Problems
(Gray Print)
Revision A
CAUSE
Ink Jet Cartridge problems
Print Head Holder broken
Print Head Holder broken
Print Head Height
Adjustment Knob set too
low
Ink on Exit Slider Rollers
Print Head Height
Adjustment Knob set too
high
Media unsuitable
Wire Form set wrong
Sliding Fence set wrong
Exit Slider Rollers set
wrong
Wiper Assembly bent or
Idler Assembly set wrong
Ink Jet Cartridge empty
9K-L USERS MANUAL
P/N 90-00860-001
Troubleshooting and Maintenance
SOLUTION
Purge ink jet cartridge.
Clean cartridge with soft cotton cloth and water.
Change to a known good cartridge.
Call Service Representative.
Call Service Representative.
Turn Knob clockwise to raise the Print Head
Clean Rollers with water to remove ink.
Turn Knob counterclockwise to lower the Print
Head
Change to a typical white wove bonded paper
Set the Wire Form to the center of the media.
Adjust the fence to within 1/16" (0.16 cm) of the
media.
Adjust exit roller to within 1/4" (6.35 mm) from
outside edges of media.
Call Service Representative.
Ink supply too low, Replace Ink Jet Cartridge
Section 7 - 2