Connecting The Printer - Bryce 9K-L User Manual

Connecting
the Printer
Note
: AB switches are
not recommended for
operation with this
printer.
Revision A
1. Locate the two long slotted tabs on the Feed Carriage
Assembly. This is where the Sliding Fence attaches to
the printer.
The drawing is shown without the Wire Form Assembly for ease of illustration.
2. Slide the rectangular shaped edge of the Sliding Fence
between the two tabs.
Connect the Address Printer to either the serial port or parallel
port of the computer. Initialize the Address Printers
communications port by sending data to either the parallel or
serial port. To change from the serial port to the parallel port
or vice versa the printer must be reinitialized or manually
changed through the Setup Menu. Doing otherwise may affect
the operation and performance of the Address Printer.
To connect printer to the computer do the following steps.
1. Align the male end of the parallel or serial cable
connector. Push the cable connector in.
2. Secure the cable in place. Use the two wire clips
located Parallel connector to snap into the tabs on the
connector. Use the thumb screws on the serial
connector to screw into the hex jack screws on the
Electrical Bracket.
9K-L USERS MANUAL
P/N 90-00860-001
Assembly of Printer Components
4
Section 3 -