Wire Form Height Adjustment; Feed Ramp Adjustment - Bryce 9K-L User Manual

Wire Form
Height
Adjustment
Feed Ramp
Adjustment
Revision A
The Wire Form Assembly helps the printer feed the media.
Use the following suggestions as a guide for setting the height
of the Wire Form Assembly. When the media is:
• Heavy media- set low
• Light media - set high.
• Rigid media - set low
To adjust the Wire Form Assembly:
1. Loosen the Carriage Knob on the Feed Carriage
Adjust Feed Ramp and Wire Form Assembly
Assembly.
2. Move the Wire Form Assembly accordingly.
3. Tighten the Carriage Knob to secure the Wire Form
Assembly in place.
Adjust the Feed Ramp Assembly beneath the rear edge of the
media by:
1. Loosen the Knob on the Feed Ramp Assembly.
2. Lower Feed Ramp beneath the back edge of the media.
Place ramp where the media is halfway up the angled
front edge.
3. Tighten Knob to lock Feed Ramp into position.
9K-L USERS MANUAL
P/N 90-00860-001
Operating the Printer
Section 4 -
10