Brother MFC-9130CW Service Manual page 64

Error message
Upper line
Drum ! Slide the Green tab
on Drum Unit.
Drum End -
Soon
Drum Stop Replace the Drum
Unit. Refer to the
instructions in the
carton of the new
drum.
Fuser Error Turn the power off,
then on again.
Leave the machine
for 15 min.
Ignore Data Press Stop Key
Jam Pull the paper tray
2-sided
completely out of
the machine.
Check inside the
machine towards
the rear. Or open
the Back Cover to
remove the
jammed paper.
Jam Inside Open the Top
Cover, pull out all
four drum and
toner cartridge
assemblies and
remove the
jammed paper.
Jam Pull out the
Manual
jammed paper
Feed
from Manual Feed
and press Start
Lower line
Immediately after power was
turned ON or the joint cover ASSY
was closed, detected that no drum
unit was set. Or the wire was
detected to be dirty.
An electric discharge error in the
drum was detected.
The number of pages printed with
each drum unit indicates that the
drum unit will reach the end of life
soon.
Electric discharge was detected
when the number of the drum unit
rotations had become more than
twice of the upper limit.
Some fuser unit errors occurred at
power-ON or upon recovery from
sleep mode.
Undecodable data is found during
printing. Undecodable PS data is
received.
After the first side is printed in
2-sided printing mode, the
registration front sensor does not
detect paper pass after a set period
of time.
After the registration rear sensor
detects the end of paper pass, the
eject sensor does not detect paper
pass.
After the manual feed sensor
detects pass of paper fed from the
manual feed slot, the registration
rear sensor does not detect paper
pass after a set period of time.
2-25
Description
Error Refer
codes to:
6208 2-51
6209
620A
6A00 2-55
6B0A 2-57
4001 2-42
4002
4003
4004
6B01 2-56
6B02
6B03
6B04
6901 2-54
--- 2-122
7700 2-60
7000 2-58
7900 2-60
Confidential