Worker Switch (Wsw) Setting And Printout (Function Code 10, 11) - Brother MFC-9130CW Service Manual

1.4.6

Worker switch (WSW) setting and printout (Function code 10, 11)

[1] Worker switch (WSW) setting (Function code 10)
<Function>
The worker switches shown in the table below can be used to set the function to satisfy
various requirements. The switch setting can be changed using the keys on the control panel.
The worker switches are factory set to confirm with the laws and regulations of the country the
machine is shipped to. Do not change these settings unless necessary.
WSW No.
WSW01
WSW02
WSW03
WSW04
WSW05
WSW06
WSW07
WSW08
WSW09
WSW10
WSW11
WSW12
WSW13
WSW14
WSW15
WSW16
WSW17
WSW18
WSW19
WSW20
WSW21
WSW22
WSW23
WSW24
WSW25
WSW26
WSW27
WSW28
WSW29
WSW30
WSW31
WSW32
Dial pulse setting
Tone signal setting
PABX mode setting
Transfer facility setting
1st dial tone and busy tone detection
Redial/Pause key setting and 2nd dial tone detection
Dial tone setting 1
Dial tone setting 2
Protocol definition 1
Protocol definition 2
Busy tone setting
Signal detection condition setting
Modem setting
AUTO ANS facility setting
Redial facility setting
Function setting 1
Function setting 2
Function setting 3
Transmission speed setting
Overseas communications mode setting
TAD setting 1
ECM and call waiting caller ID
Communications setting
TAD setting 2
TAD setting 3
Function setting 4
Function setting 5
Function setting 6
Function setting 7
Function setting 8
Function setting 9
Function setting 10
5-13
Function
Confidential