Fuel Pump Installation; Fuel Tank Removal - KYMCO PEOPLE 250 Service Manual

13
. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK

FUEL PUMP INSTALLATION

Install the fuel pump and secure it with the
two nuts.
Connect the fuel pump inlet, outlet and
vacuum tubes.
Install the met-in box and carrier.
Install the body cover, center cover and rear
fender A.
Measure the fuel pump output.
Start the engine and disconnect the fuel outlet
tube and place a clean container under the
tube to check the fuel output.
Output: 40cc/1700rpm/10 seconds .

FUEL TANK REMOVAL

Remove the floor board. ( 2-7)
Remove four nuts at the tank shield and
remove the tank shield.
Outlet Tube
Nuts
Fuel Pump
Nuts
PEOPL E 250
Vacuum Tube
Inlet Tube
Outlet Tube
Container
Tank Shield
13-20