KYMCO PEOPLE 250 Service Manual page 211

17
. IGNITION SYSTEM
A .C. GENERATOR INSPECTION
EXCITER COIL/PULSER COIL
INSPECTION
This test is performed with the stator
installed in the engine.
Remove the seat and met-in box. ( 2-6)
Disconnect the A.C. generator connector.
Measure the exciter coil resistance between
the black/white wire terminal and ground.
Black/white Ground
Measure the resistance in the XW range.
Electric tester: YF-3501
For A.C. generator removal/installation, refer
to pages 10-3 and 10-6.
Disconnect the pulser coil wire coupler.
Measure the pulser coil resistance between
the blue/white and green/white wire terminals.
Blue/Yellow Green/Whit
e
Electric tester: YF-3501
CDI UNIT
RESISTANCE INSPECTION
Measure the resistance between the terminals.
Replace the CDI unit if the readings are not
within the specifications in the table below.
8.1MW
105 110
W
Pulser Coil Wire Coupler
PEOPL E 250
17-4