KYMCO PEOPLE 250 Service Manual page 141

12
. COOLING SYSTEM
RADIATOR INSTALLATION
Install the radiator on the radiator bracket
with the two bolts and two nuts.
Connect the upper and lower hoses and
secure them with hose bands.
Connect the thermostatic switch wire.
Connect the fan motor wire couplers.
Connect the overflow tube and secure with
the tube clamp.
Fill the radiator with coolant. ( 3-9)
Connect the vent tube to the radiator filler.
After installation, check for coolant leaks.
If you want to refill the coolant , the
following procedure must be checked.
1. Please make the radiator filler and the
air vent tube to be separated.
2. Then start the engine , filled in the
coolant till the coolant flowed out
from the air vent tube.
3. Put the air vent tube on.
Connect the outlet tube of the reserve tank
and secure with the tube clamp.
Nuts
Bolts
Upper Hose
Thermostatic Switch
Wire
Air Vent Tube
Overflow Tube Fan Motor Wire Coupler
Outlet Tube of Reserve
Tank
PEOPL E 250
Radiator
Thermostatic Switch
Lower Hose
12-8