Fuel Pump Installation; Fuel Tank Removal - KYMCO Grand Dink 250 Service Manual

13
. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
GRAND DINK 250
Fuel Pump Outlet Tube Inlet Tube

FUEL PUMP INSTALLATION

Install the fuel pump and secure it with the
two bolts.
Connect the fuel pump inlet, outlet and
vacuum tubes.
Install the seat, met-in box and frame center
cover.
Vacuum Tube Fuel Strainer
Fuel Pump
Outlet Tube
Measure the fuel pump output.
Start the engine and disconnect the fuel
outlet tube and place a clean container under
the tube to check the fuel output.
Output: 40cc/1700rpm/10 seconds .
Container
Fuel Vapor Tube
Fuel Unit

FUEL TANK REMOVAL

Remove the floor board. ( 2-4)
Remove the leg shield . ( 2-5)
Disconnect the fuel unit wire connector.
Remove the fuel tube between the fuel tank
and the fuel filler.
Disconnect the fuel vapor tube.
Remove the fuel tank.
The installation sequence is the reverse of
removal.
Fuel Strainer Tube to Fuel Filler
13-20