KYMCO PEOPLE 250 Service Manual page 147

12
. COOLING SYSTEM
THERMOSENSOR
THERMOSENSOR REMOVAL
Remove the met-in box and carrier.
Remove the body cover, center cover and
rear fender cover A.
Drain the coolant.
Disconnect the thermosensor wire.
Remove the thermosensor.
THERMOSENSOR INSPECTION
Suspend the thermosensor in a pan of water
over a burner and measure the resistance
through the sensor as the water heats up.
Temperature(
)
Resistance(W)
THERMOSENSOR INSTALLATION
Apply 3-BOND No. 1212 sealant or
equivalent to the thermosensor threads and
install it into the thermostat housing.
Connect the thermosensor wire.
Fill the radiator with coolant. ( 3-9)
Install the center cover, met-in box and seat.
( 2-3)
Be sure to bleed air from the cooling
system.
50 80 100 120
154 52 27 16
Thermosensor
Thermometer
PEOPL E 250
Thermosensor
Thermosensor Wire
Thermosensor
Thermosensor Wire
12-14