Function Menu; Signaling Combination Setup; High/Mid/Low Power Selection; Band-Width Selection - AnyTone AT-778 User Manual

8

Function Menu

1. FUN
Hold key for over 2S to enter function menu.
SET
2.
Press or key to choose menu list.
VOL+ VOL—
3. Press or key to choose wanted value.
4.
Press any key to store and exit.
There are 2 part of function menu: part 1, Menu No. 1-10 channel
function menu. part 2 Menu No. 11-24 function menu. Part 1 will
automatically hide in channel mode. In FM radio receiver mode, it
is invalid to enter function menu.

Signaling Combination setup

Enter No. 01 function menu , the LCD
displays "KP:SQ".This function can improve
the level of blocking irrelative signals.
16
SQ:You can hear the calling when receive
a mathcing carrrier.
CTC:You can hear the calling when receive
a mathcing carrrier and CTCSS/DCS
signaling .
Defualt:SQ
This settting is valid only when CTCSS/DCS signaling added.

HIGH/MID/LOW Power Selection

Enter No. 02 function menu , the LCD displays
"POW:HI".
This function use to control transmit power
level.
HI:Transmit with high power.
MI:Transmit with middle power.
LO:Transmit with low power.
Defualt:HI

Band-width Selection

Enter No 03 function menu , the LCD displays
"BNAD:25".
Select suitable bandwidth in accordance with
different local conditions
25: band width is 25k(Wide band)
20: band width is 20k(Middle band)
12: band width is 12.5k(Narrow band)
Defualt:25

Busy Channel Lockout

Enter No 04. function menu , the LCD displays "BUSY:OF".
BCLO is to disable transmitting while RX
signal is received. Once the channel is busy
and you press PTT, the radio will beep as
warning and get back to receiving.
BU: Enable BCLO, Carrier lockout, trans
-mitting is inhibited when current channel
receives a matching carrier; press [PTT]
to emit error voice prompt and back to
receiving status.