Offset Frequency Direction Setup; Frequency/Channel Scan - AnyTone AT-318UV Instruction Manual

BASIC OPERATIONS

Offset Frequency Direction Setup

Under standby state, press
press key to choose offset frequency direction. There are 3 options, Positive
offset, Minus offset, shut off offset.
1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When
enable reverse function, the RX frequency is higher than TX frequency.
2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When enable
reverse function, the RX frequency is lower than TX frequency.
3. None: Indicates shut offset off.
Under frequency mode (VFO) or channel mode, press
direction(+), minus offset direction (-), shut offset off one by one (Please refer to offset frequency setup).
NOTE: This function is invalid in channel mode.

Frequency/Channel Scan

Under corresponding mode, press
key to start frequency scan or channel scan.
1. Frequency Scan
Under VFO mode, frequency scan is available. This function is used for monitoring
signal of various communication frequency by transceiver 'step' setup, press
numeric key or
16
key, the top left corner of LCD displays "
key, the top left corner of LCD displays "
key to exit.
" icon,
key then press key to choose positive offset
" icon, then press