Acs100-Pan Control Panel; Control Modes - ABB ACS 400 User Manual

ACS100-PAN Control Panel

The control panel can be connected to and detached from the converter at any time. This panel does
not support the upload and download functions when used with ACS 400, in which case ACS-PAN-A
is needed.

Control modes

Active fault indicator
Display modes
START/STOP
REVERSE
Control Modes
The very first time the drive is powered up, it is controlled from the Control Terminals (remote control,
REM). The ACS 400 is controlled from the control panel when the drive is in local control (LOC).
Switch to local control (LOC) by pressing and holding the MENU and ENTER buttons down
simultaneously until first Loc or later LCr is displayed:
• If the buttons are released while Loc is displayed, the panel frequency reference is set to the
current external reference and the drive is stopped.
• When LCr is displayed, the current run/stop status and the frequency reference are copied from
the user I/O.
Start and stop the drive by pressing the START/STOP button.
Change the shaft direction by pressing the REVERSE button (parameter 1003 must be set to
).
REQUEST
Switch back to remote control (REM) by pressing and holding the MENU and ENTER buttons down
simultaneously until rE is displayed.
Shaft Direction
FWD / REV Visible
FWD / REV Blinking rapidly
FWD / REV Blinking slowly
ACS 400 User's Manual
LOC
REM
)$8/7
6(7
OUTPUTPAR MENU FWDREV
UP/DOWN
• Shaft direction is forward / reverse
• Drive is running and at set point
Drive is accelerating / decelerating.
Drive is stopped.
Units
mAVs
kHz %
o
Crpm
Shaft direction
MENU
H@IV
/2& 5(0
GP8ÃÃS@H
(17(5
ENTER
35