Product Conformity - ABB ACS 400 User Manual

*** Follow local rules for cable cross-sections, see H. Shielded motor cable is recommended.
**** Fuse type: UL class CC or T. For non-UL installations IEC269 gG.
Note! Use 60°C rated power cable (75°C if ambient temperature exceeds 45
Note! The output contactor can be used only as a safety device. Do not close the contactor when
the ACS 400 is running.
ACS 400 is suitable for use in a circuit capable of delivering not more than 65 kA rms symmetrical
amperes, 480 V maximum.
T Product Conformity
CE Marking
The ACS 400 complies with the requirements of the European
• Low Voltage Directive 73/23/EEC with amendments
• EMC Directive 89/336/EEC with amendments
Corresponding declarations and a list of main standards are available on request.
Note! See ACS 400 EMC instructions.
A frequency converter and a Complete Drive Module (CDM) or a Basic Drive Module (BDM), as
defined in IEC 61800-2, is not considered as a safety related device mentioned in the Machinery
Directive and related harmonised standards. The CDM/BDM/frequency converter can be
considered as a part of safety device if the specific function of the CDM/BDM/frequency converter
fulfils the requirements of the particular safety standard. The specific function of the CDM/BDM/
frequency converter and the related safety standard is mentioned in the documentation of the
equipment.
UL, ULc and C-Tick Markings
All markings are for both IP 21 and IP 54 enclosures.
ACS 401 R1
ACS 401 R2
ACS 401 R3
ACS 401 R4
ACS 400 User's Manual
UL UL
á á
á á
á á
á á
°
C).
C-Tick
C
á
á
á
pending
27