ABB ACS 400 User Manual page 88

Code Description
1607 PARAM. SAVE
Parameter save function. Selection 1 (
( ) is displayed when all parameter are saved.
DONE
When parameters are altered through Standard Modbus or DDCS channels, altered values are not
automatically saved to permanent memory. Instead, this parameter must be used.
0 =
DONE
1 = ...
SAVE
Note! Parameter modifications done from the control panel are normally stored immediately to permanent
memory. However, if 1602 PARAMETER LOCK is set to 2 (
panel are saved only if this parameter 1607 is used.
78
...) saves all altered parameters to permanent memory. Value 0
SAVE
NOT SAVED
), modifications done from the control
ACS 400 User's Manual