2.0 Installation; Enclosure Installation (Step 1) - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 2.0 Installation

2.0 Installation

Only use authorized service personnel to install this system.
Because the control panel is permanently connected equipment, a readily accessible disconnect
device must be included into the building installation wiring.
Follow anti-static procedures when handling the control panel board.
Touch the earth ground terminal on the control panel board to discharge any static charge before
working on the control panel board.
To aid in system installation, this section is divided into sub-sections and labeled in a step-by-step format. Each
sub-section, or major step, might consist of several minor steps that must be completed before proceeding to
the next sub-section or major step.
2.1

Enclosure Installation (Step 1)

Use proper anchor and screw sets when installing the enclosure on non-load-bearing surfaces,
such as drywall.
1. Mount the optional EZTS Tamper Switch.
If a wall tamper is required, insert the round plastic wall plug
before mounting the enclosure.
Refer to the EZTS Cover or Wall Tamper Switch Installation
Guide (P/N: F01U003734) for complete installation
instructions.
Refer to Programming Item 137 on page 39 for enclosure
tamper options.
2. Mount the enclosure. Screws not supplied.
8 Bosch Security Systems, Inc. | 5/07 | F01U025147-01