System Setup (Wired And Wireless) - Bosch ICP-EZM2 Installer's Manual

.
1.4

System Setup (Wired and Wireless)

After the system is installed and configured, add key fobs when you add users.
Wireless support is not investigated by UL.
To install an Easy Series Intrusion Control Panel with wireless devices:
1. Follow all instructions in the wLSN Reference Guide (P/N: F01U009440) to verify adequate signal strength
exists at each device location.
2. Install all hard-wired devices, such as the control panel, control center, input and output devices, DX2010
Input Expanders, and the wireless hub.
Refer to the installation instructions supplied with each device for specific installation and configuration
instructions.
The control panel assigns wireless point numbers based on whether or not one or more DX2010
Input Expanders are connected to the control panel.
3. Install the bases for all wireless devices.
4. Apply power to the control panel.
5. Start the System Test:
- From Phone:
Start a phone session.
1.
Refer to Section 1.3 Basic Operation Information on page 4 for instructions.
From the Installer Phone Menu, press [1] for System Maintenance.
2.
Press [2] for Full System Test.
3.
Refer to Section 1.5 Installer Phone Menu on page 6.
- From Control Panel: To start the full system test, press and hold the System Test button for one
second. Refer to Section 5.0 System Test on page 56 for more information.
6. When the system announces "Install all batteries," install the batteries or remove the battery tabs from all
wireless devices. Mount the device covers on the bases.
7. When all batteries are installed and device covers are mounted, press [1] on the phone or control center to
continue.
The system identifies (discovers) new wireless devices on the system. This process takes up to 4 min to
complete. When the discovery process is complete, the system announces the number of devices
discovered.
8. When the system announces "Test all points," test each device (fault and restore), including wireless inputs
and outputs.
Refer to Section 3.1.4 Test Devices on page 24 for more information.
Point numbers are assigned to wireless devices in the order that the devices are tested (tampered
or faulted and restored). If specific point numbers are preferred for wireless devices, ensure that the
wireless devices are tested in the appropriate order. Otherwise, the system assigns the lowest
available point number to the first tested wireless device.
9. As you test each device, complete Section 4.3.5 Point Programming Items on page 46, and Section 4.3.6 Output
Programming Items on page 51.
When you restore the device, the system announces the assigned device number.
Complete Sections 4.3.5 and 4.3.6 as you test the inputs and outputs. Otherwise, you cannot cross-reference
point numbers to point descriptions in the event of a point trouble.
The control panel completes the remaining system tests and notifies you when they are complete.
10. When the control panel completes all system tests, enter Basic Programming. You can also use RPS to
program the control panel.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01
Easy Series (ICP-EZM2) | Installer Guide | 1.0 Quick Reference
5