Rom Firmware Version Items; System Programming Items - Bosch ICP-EZM2 Installer's Manual

.
4.3.1

ROM Firmware Version Items

Programming Item
Control Panel Firmware Version
Control Center 1 Firmware Version
Control Center 2 Firmware Version
Control Center 3 Firmware Version
Control Center 4 Firmware Version
4.3.2

System Programming Items

Item
Programming Item
Number
Country Code 102
103
Enclosure Tamper
Enabled
Fire Bell Cut-Off Time 107
Intrusion Bell-Cut off 108
Time
Intrusion Abort 110
Window
Intrusion Cancel 112
Window
Chime Tone Select 114
Chime Mode 115
Operation After
System Off
Automatic Test Report 116
Frequency
RPS Passcode 118
Daylight Saving Time 121
Operation
Default = Country-specific default. Select this programming item to hear the updated default value.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01
Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
Item Number Description
090 System announces the installed firmware version.
This item is read-only.
091 System announces the installed firmware version for the selected
control center. These items are read-only.
092
093
094
Description (Range)
Select the appropriate code for country-specific operation and
programming defaults (00 to 65).
0 = Enclosure tamper input disabled
1 = Enclosure tamper input enabled
Enter how long the fire alarm sounds at bell outputs and at the control
center (0 to 90 min).
Enter how long the intrusion alarm sounds at bell outputs and at the
control center (0 to 90 min).
Enter how long the control panel waits to send an alarm report after
an alarm occurs (15 to 45 sec).
Enter how long a user has to cancel an intrusion alarm report after the
system sends the report to the central station (5 to 10 min).
Select a Chime tone:
1 = Chime door bell
2 = Single chime
3 = Standard door bell
Determines Chime Mode operation after the system is turned off.
0 = Off
1 = On
2 = Follows previous setting (either on or off)
Determines how often the control panel sends the automatic test
report.
0 = No automatic test report
1 = Daily (refer to Programming Items 143 and 144 on page 40)
2 = Weekly (refer to Programming Item 145 on page 40)
3 = Monthly (refer to Programming Item 146 on page 40)
Enter the 6-digit passcode that allows access to the control panel
from RPS. Use digits 0 to 9 and A to F.
0 = No time adjustment
1 = North America
(prior to 2007)
2 = Europe and Asia
3 = Tasmania, Australia
4 = Rest of Australia
5 = New Zealand
6 = Cuba
7 = South America and
Antarctica
8 = Namibia, Africa
9 = USA after 2006
Entry
58
1
5
5
30
5
1
0
0
123456
1
37