3.0 Point Expansion; Establishing The Wireless Network And Configuring Wireless Devices; Discover New System; Establish And Configure The Wireless Network - Bosch ICP-EZM2 Installer's Manual

.

3.0 Point Expansion

For complete wireless installation and configuration information, refer to the wLSN Reference Guide
(P/N: F01U009440) supplied with the wireless hub, and the installation instructions supplied with each wireless
device.
Wireless support is not investigated by UL.
3.1

Establishing the Wireless Network and Configuring Wireless Devices

In order for the wireless network to operate properly, the following process must occur as shown below.
Discover Establish
Devices Network
3.1.1

Discover New System

Discovery is the process through which the wireless hub identifies and includes new (undiscovered)
devices into the system.
You can only perform the new system discovery process once. To update an existing wireless
system, refer to Section 3.2 Wireless Maintenance on page 26.
There are three ways to start the discovery process on a new system:
•
System Test Button:
Ensure that all devices have exited RFSS Mode.
1.
Press and hold the System Test button for one second.
2.
The device discovery process automatically starts at the beginning of the Point Test.
•
Wireless Configuration Menu:
Start a phone session.
1.
Refer to Section 1.3 System Setup on page 5 for phone session options.
From the Installer Menu, select System Maintenance, and then select Wireless Configuration.
2.
The device discovery process automatically starts.
•
Point Test:
Start a phone session.
1.
Refer to Section 1.3 System Setup on page 5 for phone session options.
From the Installer Menu:
2.
Press [1] to select System Maintenance, and then press [2] to select Full System Test.
-
The discovery process starts at the beginning of the Point Test.
Press [1] to select System Maintenance, and then press [3] to select System Test Menu. From the
-
System Test Menu, press [5] to select Point Test.
The discovery process starts at the beginning of the Point Test.
3.1.2

Establish and Configure the Wireless Network

The wireless hub automatically establishes and configures the wireless network.
The wireless hub evaluates each available radio frequency (RF) for noise, RF signal strength, and other
adjacent wireless systems. The wireless hub then selects the frequency with the lowest amount of noise and
least amount of traffic for network operation.
To configure the wireless network, the wireless hub selects the best channel for broadcasting. Once a channel
is selected, the wireless hub then configures all discovered devices to operate on the selected frequency. This
process takes several minutes.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01
Easy Series (ICP-EZM2) | Installer Guide | 3.0 Point Expansion
Configure Configure
Network Devices
OR
Inputs and Outputs
(Point Test)
Key Fobs
(Add/Change User Menu)
23