Programming Key - Bosch ICP-EZM2 Installer's Manual

Easy Series (ICP-EZM2) | Installer Guide | 4.0 Programming
4.5

Programming Key

1. If the system is on, turn it off.
2. Place the key's lock switch in the desired position.
Verify the switch position before inserting the programming key into the control panel board. An
incorrect switch position might overwrite programming data.
3. Insert the key into the control panel board.
- Auto Transfer: If Expert Programming Item Number 123 = 1 (refer to Programming Key Auto Transfer on
page 38), the programming key automatically transfers data depending on the position of the lock
switch.
- Manual Transfer: If Expert Programming Item Number 123 = 0, you must use the Installer Menu to
access the programming key.
The control center announces when data transfer is completed.
4. When the √ LED flashes green, data transfer is successful. If the √ LED flashes red, the data transfer is
unsuccessful.
Bosch recommends that you transfer the programming data to the ICP-EZPK Programming Key
when you finish programming the control panel.
54
OR
Send data from control panel to key.
Send data from key to control panel.
Bosch Security Systems, Inc. | 5/07 | F01U025147-01